• +91-9223503903
  • Solution Provider

    Of Industrial Automation

  • Distributor

    Of Industrial Spares

Model 230 Two Conductors, 30 Amps

Disconnects included (4 lg.)
Boot Kit available
Available with stainless steel ball bearing (230-SS)

Model No. Terminals Voltage AC/DC Max Amp Rating Max. Freq. MHz Contact Resistance Max. RPM Temp
Max.F(C) / Min. F (C)		 Rotation Torque
(gm-cm)		 Circuit Separation
230 2 0-250 30 200 <1m 1800 140 (60) /-20(-29) 200 >25M
230-SS 2 0-250 30 200 <1m 1800 140 (60) /-20(-29) 200 >25M

"SS" designator indicates stainless steel ball bearing (recommended for wet or corrosive environments)

Model 230 Accessories

55251

Terminal 16 - 14 AWG (qty. 2 included)



55250

16 - 14 AWG (qty. 2 included) Terminals for other wire gauges available. (22-18 AWG and 12-10 AWG)

57230

Boot Kit for dust / splash protection IP51

Model 230 Standard Wire Connections

Model 230 Wire Connections With Optional Boot Kit

Stationary end showing optional boot kit.


Wire connections, mounted inside rotating shaft.

Stationary end showing optional boot kit.


Wire connections, mounted inside rotating shaft

Model 230 Suggested Mounting Methods

Model 230 is typically mounted by the black body or the white plastic bushing on either end using a set screw. When mounting horizontally, mount the Mercotac so the body of the connector rotates.

Typical Body Mount Hole Dimensions
MODEL HOLE DIAMETER (Ø) * DEPTH
230 et al .998" (25.35) .80" (20)
Typical Bushing Mount Hole Dimensions
MODEL HOLE DIAMETER (Ø) * DEPTH
230 et al .500" (12.70) .40" (10)
*Inch (mm) Tolerance Ø +.001" (+.025)
-.000" (-.000)

Installation Notes:

  • The up arrow should not point below horizontal
  • Do not solder to or bend connector tabs
  • Avoid lateral forces and mechanical loads (overly stiff or tight wires)
  • Do not rigid mount both ends of connector
  • Limit mounting eccentricity (runout / wobble) to .005" (.13mm)
  • Provide overload protection within the circuit
  • Avoid vibration and bumping motions