• +91-9223503903
  • Solution Provider

    Of Industrial Automation

  • Distributor

    Of Industrial Spares

Model 235 Two Conductors, 2@30amps & 500V

Disconnects included (4 lg.)
Boot Kit available
Available with stainless steel
ball bearing (235-SS)

Model No. Terminals Voltage AC/DC Amp Rating @500VAC Max. Freq. MHz Contact Resistance Max. RPM Temp
Max.F(C) / Min. F (C)		 Rotation Torque
(gm-cm)		 Circuit Separation
235 2 0-250 30 100 <1m 1200 140 (60) /-20(-29) 400 >50M
235-SS 2 0-250 30 100 <1m 1200 140 (60) /-20(-29) 400 >50M

"SS" designator indicates stainless steel ball bearing (recommended for wet or corrosive environments)

Model 235 Accessories


55251

Terminal 16 - 14 AWG (qty. 2 included)


55250

16 - 14 AWG (qty. 2 included)

Terminals for other wire gauges available. (22-18 AWG and 12-10 AWG)

57235

Boot Kit for dust or splash protection IP51

Model 235 Standard Wire Connectionss

Model 235 Wire Connections With Optional Boot

Model 235 Suggested Mounting Methods

Model 235 is typically mounted by either the black body or the white plastic bushing on either end using a set screw. When mounting horizontally, mount the Mercotac so the body of the connector rotates.

Typical Body Mount Hole Dimensions
MODEL HOLE DIAMETER (Ø) * DEPTH
235 et al 1.248" (31.7) .80" (20)
Typical Bushing Mount Hole Dimensions
MODEL HOLE DIAMETER (Ø) * DEPTH
235 et al .748" (19.0) .40" (10)
*Inch (mm) Tolerance Ø +.001" (+.025)
-.000" (-.000)

Installation Notes:

  • The up arrow should not point below horizontal
  • Do not solder to or bend connector tabs
  • Avoid lateral forces and mechanical loads (overly stiff or tight wires)
  • Do not rigid mount both ends of connector
  • Limit mounting eccentricity (runout / wobble) to .005" (.13mm)
  • Provide overload protection within the circuit
  • Avoid vibration and bumping motions