• +91-9223503903
  • Solution Provider

    Of Industrial Automation

  • Distributor

    Of Industrial Spares

Model 4100 Four Conductors, 3@100amps & 1@60amps 500V




Wire connection clamps included

Model No. Terminals Voltage AC/DC Amp Rating @500VAC Max. Freq. MHz Contact Resistance Max. RPM Temp
Max.F(C) / Min. F (C)		 Rotation Torque
(gm-cm)		 Circuit Separation
4100 4 0-500 3@100,1@60 100 <1m 100 160(70) /-20(-29) 2500 >50M
235-SS 2 0-250 30 100 <1m 1200 140 (60) /-20(-29) 400 >50M

Connector housing material is anodized aluminum

Model 4100 Accessories


41080

Grounding Collar w/ screw (qty 2 included)


41081

Tab Clamp w/ screws (qty 6 included)

Model 4100 Standard Wire Connections

Model 4100 Suggested Mounting Methods

Model 4100 is typically mounted by the black anodized aluminum body using a set screw. When mounting horizontally, mount the Mercotac so the body of the connector rotates. For vertical orientation with the rotating member above, mount to the model 4100 top (gray) plastic bushing.

Typical Body Mount Hole Dimensions
MODEL HOLE DIAMETER (Ø) * DEPTH
4100 2.365" (60.07) 3.00" (76.2)
Typical Bushing Mount Hole Dimensions
MODEL HOLE DIAMETER (Ø) * DEPTH
4100 2.365" (60.07) 2.50" (63.5)
*Inch (mm) Tolerance Ø +.001" (+.025)
-.000" (-.000)

Installation Notes:

  • The up arrow should not point below horizontal
  • Do not solder to or bend connector tabs
  • Avoid lateral forces and mechanical loads (overly stiff or tight wires)
  • Do not rigid mount both ends of connector
  • Limit mounting eccentricity (runout / wobble) to .005" (.13mm)
  • Provide overload protection within the circuit
  • Avoid vibration and bumping motions