• +91-9223503903
  • Solution Provider

    Of Industrial Automation

  • Distributor

    Of Industrial Spares

Model 630 Six Conductors, 2@4amps, 4@30amps


Disconnects included (4 sm., 8 lg.)
Boot Kit available
Available with stainless steel ball bearing (630-SS)

Model No. Terminals Voltage AC/DC Amp Rating @500VAC Max. Freq. MHz Contact Resistance Max. RPM Temp
Max.F(C) / Min. F (C)		 Rotation Torque
(gm-cm)		 Circuit Separation
630 6 0-250 2@4/4@30 100 <1m 300 140 (60) /-20(-29) 700 >25M
630-ss 6 0-250 2@4/4@30 100 <1m 300 140 (60) /-20(-29) 700 >25M

"SS" designator indicates stainless steel ball bearing (recommended for wet or corrosive environments)

Model 630 Accessories

55110

22 - 18 AWG (qty. 4 included)

55253

Shrink Tube (qty. 4 included)


55252

Terminal 16 - 14 AWG (qty. 4 included)


55251

Terminal 16 - 14 AWG (qty. 4 included)

57630

Boot Kit for dust and splash protection IP51

Model 630 Standard Wire Connections

Model 630 Wire Connections With Optional Boot Kit

Model 630 Suggested Mounting Methods

Model 630 is typically mounted by either the black body or the white plastic bushing on either end using a set screw. When mounting horizontally, mount the Mercotac so the body of the connector rotates.

Typical Body Mount Hole Dimensions
MODEL HOLE DIAMETER (Ø) * DEPTH
630, et al 1.575" (40.00) .80" (20)
Typical Bushing Mount Hole Dimensions
MODEL HOLE DIAMETER (Ø) * DEPTH
630, et al .875" (22.23) .40" (10)
*Inch (mm) Tolerance Ø +.001" (+.025)
-.000" (-.000)

Installation Notes:

  • The up arrow should not point below horizontal
  • Do not solder to or bend connector tabs
  • Avoid lateral forces and mechanical loads (overly stiff or tight wires)
  • Do not rigid mount both ends of connector
  • Limit mounting eccentricity (runout / wobble) to .005" (.13mm)
  • Provide overload protection within the circuit
  • Avoid vibration and bumping motions